-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
Lipo Voltage Checker 1S-8S with Buzzer Alarm
Features :
- Input: 1S-8S Battery
- Battery type: Lipo/LiFe/Li-ion/LiMn
- It has a Buzzer Alarm for low voltage indication.
- Useful for measuring each cell voltage.
- It has a mode button at the top for setting the desired voltage value.
₹146.00 (excl. GST)Lipo Voltage Checker 1S-8S with Buzzer Alarm
₹146.00 (excl. GST) -
MT8870 DTMF Audio/Speech Decoding Telephone Module
Features:
- Onboard voice input interface
- Low power consumption
- Internal gain setting amplifier
- Onboard LED, it is very convenient to check the output state.
- Adjustable guard time
- Central office quality
- Onboard 3.5mm input interface
- 5 Channel interface
- On-board MT8870 frequency decoder chip
- Power-down mode
- Inhibit mode
- Onboard audio input interface
- Onboard LED lights for output state indication Complete DTMF Receiver.
- Does not require external circuits or wiring, it can be inserted directly into the UNO/MEGA2560/DUE board to use.
- 12-Digital outputs decode mobile and fixed telephone keys (0-9, * #). Also, another 4 Digital output(ABCD) can use “DTMF Dial” for Software control.
₹147.00 (excl. GST)MT8870 DTMF Audio/Speech Decoding Telephone Module
₹147.00 (excl. GST) -
Motion Sensor Detector Module Board Device with Relay
- Country of Manufacture: INDIA ; Material: Plastic, Metal
- Number of control devices:1
- Sensor: Infrared Motion Sensor
- Input voltage: 9V 1A
- Output voltage: 7A 250 V,12A 120V
₹150.00 (excl. GST)Motion Sensor Detector Module Board Device with Relay
₹150.00 (excl. GST) -
ACS712 – 30A Range Current Sensor Module
- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 µs output rise time in response to step input current
- Small footprint, low-profile SOIC8 package
- 2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
- Supply Voltage: 4.5V~5.5V DC
- Measure Current Range: 30A
- Sensitivity: 100mV/A
₹150.00 (excl. GST)ACS712 – 30A Range Current Sensor Module
₹150.00 (excl. GST) -
Esp8266-12E WIFI Module
- WS2812 Led on board.
- 802.11 b/g/n
- Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
- Integrated TR switch, balun, LNA, power amplifier and matching network
- Integrated PLL, regulators, DCXO and power management units
₹150.00 (excl. GST)Esp8266-12E WIFI Module
₹150.00 (excl. GST) -
Key Display For AVR, Boards compatible | New 8-Bit Digital LED Tube 8-Bit TM638 Module | Robotics Science Project
- It only need to read the relevant register to send display data or test button so it save mcu resources effectively., Package contents: 1 key display module for avr arduino
- 8 bits, 8 keys, 8 leds, 8 digital tubes, common cathode led digital tube
- The advantage is only three io ports will be occupied when it drives
- Scm doesn’t need to work for scaning display and key scaning
₹150.00 (excl. GST) -
Resistor Kit 150 Pieces 30 Values 1/4W for Electronics DIY
- Carbon film assorted resistors
- 30 values
- Quantity: 150 pieces (5 each)
- Tolerance: 5%
- Power Rating: 0.25 wat
₹150.00 (excl. GST)Resistor Kit 150 Pieces 30 Values 1/4W for Electronics DIY
₹150.00 (excl. GST) -
12V 2A DC Power Adapter
- Universal
- Power Consumption: 60 W
- Power Cord Included
₹150.00 (excl. GST)12V 2A DC Power Adapter
₹150.00 (excl. GST) -
5V 2Amp Adapter (5 V – 2 A DC SMPS)
- Compatible with Dth,STB,CCTV,toys,broad band,laptop,DVD,tablet,TV tuner card,cordledd phones,LCD moniter,scanner,cell phone,printers
- Dual Output Pin: DC Pin + Sony Pin
- Ideal for CCTV Cameras / Routers / Modems / Cordless Phones / Set Top Boxes / Wireless Devices / POS Machines etc.
- Simple to use, just plug-in, charge up and play
- The official power adapter allows you to charge your handheld console with any two-pin socket
- Compatible with Dth,STB,CCTV,toys,broad band,laptop,DVD,tablet,TV tuner card,cordledd phones,LCD moniter,scanner,cell phone,printers
- Dual Output Pin: DC Pin + Sony Pin
- Ideal for CCTV Cameras / Routers / Modems / Cordless Phones / Set Top Boxes / Wireless Devices / POS Machines etc.
₹150.00 (excl. GST)5V 2Amp Adapter (5 V – 2 A DC SMPS)
₹150.00 (excl. GST) -
150W DC-DC Boost Converter 10-32V to 12-35V 6A Step-Up Adjustable Power Supply
Features :
- The non-isolated step-up power conversion module
- Onboard LED illuminates when the voltage is applied to the module
- Equips Multi-turn Potentiometer.
- Easy to drive 65W 90W dual-core notebook.
- The output voltage is continuously adjustable on OUT+ and OUT- screw terminals (Output voltage must be greater than input voltage)
₹150.00 (excl. GST)150W DC-DC Boost Converter 10-32V to 12-35V 6A Step-Up Adjustable Power Supply
₹150.00 (excl. GST) -
₹150.00 (excl. GST)
Rubber Band Powered Aircraft Model Kits Toy
₹150.00 (excl. GST) -
Portable Resistor LED Potentiometer Kit for UNO R3
- 1 sets Handy Portable Resistor Kit for Arduino Starter Kit UNO R3 LED potentiometer tact switch pin header
- High Quality kit for arduino
₹150.00 (excl. GST)Portable Resistor LED Potentiometer Kit for UNO R3
₹150.00 (excl. GST)
