-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
MQ-8 Hydrogen Gas Sensor Module H2 Alarm Detection
- Using high-quality dual-panel design, with power indicator and TTL signal output instructions.
- The switching signal having a DO (TTL) output and analog output AO.
- TTL output valid signal is low.
- The higher the voltage, the concentration of the analog output voltage is higher.
- A hydrogen gas detection with good sensitivity.
- Has a long life and reliable stability
₹80.00 (excl. GST)MQ-8 Hydrogen Gas Sensor Module H2 Alarm Detection
₹80.00 (excl. GST) -
Proto Shield Prototype expansion board for Arduino UNO
Features:
Power rails down the middle and sides
A reset button and an extra general use button
2x 3mm general use LEDs, red and green, as well as 2 matching resistors
A pass-thru ICSP stacking header so you can stack any kind of shield on top, and/or use an AVR programmer
A surface-mount chip area for up to 14 SOIC size parts
Compatible with tiny breadboards
Every pin is brought out
Gold plated pads₹82.00₹90.00(excl. GST)Proto Shield Prototype expansion board for Arduino UNO
₹82.00₹90.00(excl. GST) -
MP3-TF-16P MP3 SD Card Module with Serial Port
Application
- Car navigation voice broadcast
- Road transport inspectors, toll voice prompts
- The train station, bus station voice prompts security check
- Electric power, telecommunications, financial operating room voice prompts
- The vehicle into or out of the channel to verify the voice prompts
- Border control channel voice prompts
- Multi-channel voice alarm or voice guidance equipment operation
- Electric sightseeing bus safety with voice notices
- Electrical and mechanical equipment failure alarm
- Fire alarm voice prompts
- Automatic broadcasting equipment, regular broadcast.
Specifications and Features :
- Supports sampling rates (kHz): 8 / 11.025 / 12/16 / 22.05 / 24/32 / 44.1 / 48.
- 24-bit DAC output, dynamic range support: 90dB, SNR support: 85dB.
- Fully supports FAT16, FAT32 file system, maximum support 32G TF card, support U disk to 32G, 64M bytes of NOR FLASH.
- A variety of control modes are available. IO control mode, serial mode, AD key control mode.
- The broadcast language spots feature, you can pause the background music being played. Advertising finished playing back background sound to continue playing.
- The audio data is sorted by folder, supports up to 100 folders, folders can assign every 255 Tracks
7,30 level adjustable volume, adjustable EQ 6.
₹82.00 (excl. GST)MP3-TF-16P MP3 SD Card Module with Serial Port
₹82.00 (excl. GST) -
696ZZ Bearing 6x15x5 Stainless Steel Shielded Miniature Bearings (4Pcs)
696ZZ Bearing 6x15x5
- Model: 696ZZ
- Inside diameter (ID): 6 mm.
- Outside diameter (OD): 15 mm.
- Width: 5 mm.
- Weight: 16 gm. (Each has 3 gm).
₹82.00 (excl. GST)696ZZ Bearing 6x15x5 Stainless Steel Shielded Miniature Bearings (4Pcs)
₹82.00 (excl. GST) -
IRS2104 PDIP-8 Gate Driver
IRS2104 PDIP-8 Gate Driver
Features:
- Floating channel designed for bootstrap operation
- Fully operational to +600 V
- Tolerant to negative transient voltage, dV/dt immune
- Gate drive supply range from 10 V to 20 V
- Undervoltage lockout
- 3.3 V, 5 V, and 15 V input logic compatible
- Cross-conduction prevention logic
- Internally set deadtime
- High-side output in phase with input
- Shutdown input turns off both channels
- Matched propagation delay for both channels
₹82.00 (excl. GST)IRS2104 PDIP-8 Gate Driver
₹82.00 (excl. GST) -
8mm Bore Inner Ball Mounted Pillow Block Insert Bearing KP08
8mm Bore Inner Ball Mounted
- Type: KP08
- Material: zinc alloy
- Bore Diameter:8mm
- Mounting Hole Diameter: 5 mm
- Durable with high precision
- Can withstand great weight
₹83.00 (excl. GST)8mm Bore Inner Ball Mounted Pillow Block Insert Bearing KP08
₹83.00 (excl. GST) -
Official Raspberry Pi 5 Camera FPC Cable – 200mm
- FPC Cable Type: Camera Cable
- Length: 200 mm
₹83.00 (excl. GST)Official Raspberry Pi 5 Camera FPC Cable – 200mm
₹83.00 (excl. GST) -
Official Raspberry Pi 5 Camera FPC Cable – 200mm
- FPC Cable Type: Camera Cable
- Length: 200 mm
₹83.00 (excl. GST)Official Raspberry Pi 5 Camera FPC Cable – 200mm
₹83.00 (excl. GST) -
Metal Robot Chassis for 4WD Robo Car
- Metal Body
- Available in two color red & grey
- Many perforated holes have given for easy attachment of the development board and sensors
- Center Shaft gear motor and side shaft gear motor can be used for this chassis.
₹85.00 (excl. GST)Metal Robot Chassis for 4WD Robo Car
₹85.00 (excl. GST) -
Nano And Uno Multi-Purpose Expansion Board For Nano 3.0
- Compatible with Arduino NANO
- All digital and analog pins breakout
- Compact size;
- External power supply current support
- Leads all pins out, convenient for wiring and doing experiments.
₹85.00 (excl. GST)Nano And Uno Multi-Purpose Expansion Board For Nano 3.0
₹85.00 (excl. GST) -
₹85.00 (excl. GST)USB to TTL Serial Converter Adapter Cable
₹85.00 (excl. GST) -
₹85.00 (excl. GST)6 Feet USB 2.0 to RS232 DB9 Serial Adapter Cable
₹85.00 (excl. GST)
