-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
51-152 Steel Shaft Claw Hammer
- Shaft 15% longer for better balance and control
- Soft grip ergonomic handle for comfort and grip
- Fully heat treated carbon steel head for strength,durability and safety
₹200.00 (excl. GST)51-152 Steel Shaft Claw Hammer
₹200.00 (excl. GST) -
Wood Handle Ball Pen Hammer
- 24 torque stabilizing bars
- AntiVibe patented tuning fork
- Bright colour accents, easy to find on work site
- Graphite core shaft for maximum strength
- One-piece forged construction for strength and durability
- Patented Anti-Vibe™ technology reduces vibration transmitted to wrist and elbow
- Patented head to handle assembly for improved safety
- Precision balanced
₹350.00 (excl. GST)Wood Handle Ball Pen Hammer
₹350.00 (excl. GST) -
5 in 1 Stainless Steel Tweezer Set
- This craft tweezer set made of high strength stainless steel with, process by heat treatment and hardening to make the tweezers high elasticity
- The tip of the tweezers has a high hardness and can be used for precise operation such as board soldering or watch repair.
- We have a professional team and always ready to provide the best service
₹400.00 (excl. GST)5 in 1 Stainless Steel Tweezer Set
₹400.00 (excl. GST) -
84-096-23 127mm-5 Needle Nose Miniature Plier
- Long tempered jaws for working in hard to reach areas
- Forged steel construction
- Rust resistant finish
- Double dipped handle for comfort | Meets or exceeds ANSI standards
₹400.00 (excl. GST)84-096-23 127mm-5 Needle Nose Miniature Plier
₹400.00 (excl. GST) -
Stanley Bent Nose Pliers 200mm
The angled nose is capable of gripping and maneuvering objects in obstructed situations
Bent nose plier 6”, 8” carbon steel polished₹300.00 (excl. GST)Stanley Bent Nose Pliers 200mm
₹300.00 (excl. GST) -
Stanley 84-214-22 Wire Stripper 130mm
- Size: 130mm / 5 1/4- Inch
- Convenient hole for looping or bending wire
- Ideal for cutting, stripping speaker wire, appliance cords, etc
- Slide adjust for various gauge wire
₹200.00 (excl. GST)Stanley 84-214-22 Wire Stripper 130mm
₹200.00 (excl. GST) -
Stanley Combination Mini Plier, For Cutting, Size: 205 mm
- Color: Yellow and Black, Material: Plastic and Sturdy Steel
- Jaws and Cutting Edge are Induction Hardened & Tempered
- Black phosphate finish anti-rust protected
- Anti-rust Protected
- Package Contents: 1-Piece Plier
- Limited lifetime warranty offered on the product
₹450.00 (excl. GST)Stanley Combination Mini Plier, For Cutting, Size: 205 mm
₹450.00 (excl. GST) -
Stanley PLIER Long Nose, 203mm-8
- Features – Forged Steel Construction, Double dipped handles, Rust Resistant Finish
- Specifications – Part No. 84-102, Size: 203mm / 8″ Long Nose Plier
- Applications – Electric and Household applications
₹400.00 (excl. GST)Stanley PLIER Long Nose, 203mm-8
₹400.00 (excl. GST) -
External Nose Circlip Plier – 5 inch -84-332-23
- Limited lifetime warranty offered on the product
- This product comes in a proper packaging
- The first clamp fine polishing and processing blackening, good looking
₹350.00 (excl. GST)External Nose Circlip Plier – 5 inch -84-332-23
₹350.00 (excl. GST) -
Mini Hacksaw Blade 150mm
Here the hacksaw blades come in handy. These blades are fine-tooth saw blades, mainly made to cut metal.
₹250.00 (excl. GST)Mini Hacksaw Blade 150mm
₹250.00 (excl. GST) -
Mini Portable Digital Clamp Meter
- AC CURRENT RANGE: 10MA ~ 20A, 100MA ~ 200A, 1A ~ 400A.
- OVERLOAD PROTECTION: 400A ON ALL RANGES
- AC VOLTAGE: RANGE 1V ~ 450V
- DC VOLTAGE: RANGE 1V ~ 600V. OVERLOAD PROTECTION: 600V DC / (PEAK AC) ON ALL RANGES.
- RESISTANCE MEASUREMENT: 200K OHM RANGE.
₹550.00 (excl. GST)Mini Portable Digital Clamp Meter
₹550.00 (excl. GST) -
Mini Mutimeter -DT830D
Mini Multimeter-DT830D
1 piece each multimeter and bread board. All our products are made from quality items. We recommend that you read labels, warnings and directions of all products before use and not rely solely on the information. Care instruction keep away from the items or products which may cause damage to this product.
₹175.00 (excl. GST)Mini Mutimeter -DT830D
₹175.00 (excl. GST)