N20 12V 300RPM Micro Metal Gear Motor With Encoder

310.00

Features :

  1. Model: GA12 N20.
  2. This is a DC Mini Metal Gear Motor, ideal for making robots
  3. Lightweight, high torque and low RPM.
  4. Fine craftsmanship, durable, not easy to wear.
  5. With excellent stall characteristics, can climb hills easily.
  6. You can also easily mount a wheel on the motor’s output shaft.
  7. Motor Size: 15 x 12 x 10 mm.
  8. Gearbox Length: 9 mm.
  9. Count: 3PPR(Pulse per Revolutions).

How to do wiring :

  1. Red – motor Power  (Exchange can control the motor positive and negative rotation).
  2. Black – encoded power supply(VCC) – Positive (positive 3.3-5v).
  3. Yellow – signal feedback (motor turns 2 signals).
  4. Green – signal feedback (motor turns 2 signals).
  5. Blue – encoded power(GND).
  6. White – Motor power (Exchange can control the motor positive and negative rotation).

Dimensions :

N20 12V 60 Rpm Micro Metal Gear Motor With Encoder

SKU: OLEG0001 Category:

Description

Micro metal gear motor

These N20 12V 300RPM Micro Metal Gear Motor With Encoder is intended for use at 12 V. Though in general, these kinds of motors can run at voltages above and below this nominal voltage; so they should comfortably operate in the 3 – 12 V range (rotation can start at voltages as low as 0.5 V).

Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor. The micro metal gear motors are available in a wide range of gear ratios—from 5:1 up to 1000:1. With the exception of 1000:1 gear ratio versions, all of the micro metal gear motors have the same physical dimensions; so one version can be easily swapped for another if your design requirements change.

Additional information

Weight 11 g
Dimensions 6 × 4 × 3 cm
Rated Operating Voltage (VDC)

12

No Load Current (mA)

50

Stall Current (A)

0.3

Rated Speed (RPM)

240

Rated Torque(kg-cm)

0.5

Stall Torque(Kg-Cm)

4

No load Speed (RPM)

300

Gear Ratio

100 : 1

Shaft Type

D-type
Single Side

Shaft Diameter (mm)

3

Reviews

There are no reviews yet.

Be the first to review “N20 12V 300RPM Micro Metal Gear Motor With Encoder”

Your email address will not be published. Required fields are marked *